Fluke DSP-2000 Uživatelský manuál stáhnout pdf (Strana 44)

DSP-100/2000

Users Manual

2-28

Setting the Power-Down Timer

To extend battery life, you can set the power-down timer to automatically switch

the test tool to a low-power mode after a selected period of inactivity. You can

also disable the power-down timer.

When the test tool switches to low-power mode, the display goes blank. To

reactivate the display, press C.

To set the power-down timer or enable/disable the timer, proceed as follows:

1. Turn the rotary switch to SETUP.

2. Press $Page Down once.

3. Use D to highlight the power-down timer status.

4. Press ! Choice.

5. Use D U to highlight the desired time-out period or the enable/disable

status.

6. Press E to accept your selection.

Model DSP-2000 turns itself off if not used for 30 minutes after power-down.

When this happens, pressing C turns on the test tool. The test tool then goes

through its power-on sequence as though it were turned on with the rotary switch.

Enabling or Disabling the Audible Tones

To enable or disable the test tool’s audible tones, proceed as follows:

1. Turn the rotary switch to SETUP.

2. Press $Page Down twice.

3. Use D to highlight the audible tone status.

4. Press ! Choice.

5. Use D U to highlight the desired enable or disable status.

6. Press E to accept your selection.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 195 196

Žádné komentáře

Fluke DSP-2000 Uživatelský manuál Strana 44